In the process of cutting the equipment of the slitter machine manufacturer, the width and scale of the strip is not accurate because of the influence of some factors. This will affect the strip shear quality, so the need to prevent. Next, let's briefly analyze the main reasons for the poor shearing width scale of the sundering machine manufacturer.

First, in the process of operation of the equipment of the sundering machine manufacturer, if there is a problem of lateral swing of the tool, it will lead to poor scale, for example, the transverse swing of the tool and the outside diameter of the tool are different and bad. Because the lateral swing value of the tool cannot be zero. Generally, the lateral swing value of the load is about 0.03-0.05mm. The reason is the error of cutter thickness, inner diameter, width of distance sleeve and the warping of the lateral stress during the shearing of thick plate.

Secondly, during the production period of the sundering machine factory equipment, because of the problem of transverse warping of the steel plate, the width and scale are poor. This is because in the condition of transverse warpage, the cut product measurement is larger than the set value of the knife.

Third, with the production and operation of the equipment of the sundering machine manufacturer, there are certain coordination errors in the distance sleeve and cutting tools. Under normal circumstances, the thickness accuracy of distance sleeve and tool is 0.005. When the number of pieces is larger, the cumulative error becomes larger.

The third reason is because the establishment of the public service is bad. You should know that the total width of the products cut by the sundering machine manufacturer is slightly larger than the size of the product side of the knife. So the need to guess in advance of this poor degree. Refer to the measurement of the distance sleeve when the knife is matched on the product side.

Finally, the choice of cutting method should be taken into account. In contrast, if the sating machine factory equipment is used to cut straight, then the tension of the steel coil will increase, the transverse warping will disappear, and the scale will go down.