We know that the precision of the equipment is constantly improving during the splitting process. In order to achieve accuracy, the cutting quality must be ensured. What can be considered a good cut quality? In fact, for the sundering machine, it is not completely cut off the material, but the shear section and fracture section exist cutting results.

This cutting quality not only ensures the accuracy of the product, but also reduces tool wear and extends the service life of the slicing machine equipment. To achieve this, care must be taken not only to control each gap, but also to select the appropriate pressure plate at the cutoff point. We know that the cutoff resistance at the cutoff point causes bending, deformations and other deformations of the material.

Not only that, in this area, to avoid electroplating terminal materials more likely to scratch, so it is necessary to choose the appropriate form of pressure plate. At the same time, cutting processing electrical materials, but also need to improve seepage quality, safe production, reduce operating costs. At this point, it is necessary to match the cutter's tool holder. When designing tool rest, attention should be paid to setting horizontal spacing and easy overlap.

During the operation of the stripping device, the cutting work can be guaranteed to be stable within the set range. In addition, the horizontal position of the tool shaft needs to be adjusted. Horizontal spacing can be set numerically in the operation panel, and the position of the lower axis can be monitored and adjusted in real time during operation to minimize changes in horizontal spacing caused by expansion.

Combined with the above introduction, it can be seen that in the operation of paper cutting equipment, the quality of paper cutting must be strictly controlled. Not only should we pay attention to reasonable operation, but also pay attention to the control of its various devices, affecting the cutting quality and product roll shape. In particular, the drive and control of the cutter shaft and the speed control of the material are very important.