Stripe machine fault analysis and metal stripe machine attention matters

About the website products and key words, the following will be to explain in detail one of them, is for the stripe machine, mainly some of its new knowledge content, so that we can learn from it and move forward, in this way, we can continue to deepen the understanding of the product, and reach the expected policy and requirements.

1. What are the details of the stripe machine? How was the base obtained?

Slitting machine, briefly speaking, it is a kind of mechanical equipment that can slitting strips into a number of required specifications and sizes, so that the finished product can be used later. Generally speaking, the base of the splitting machine, is made of steel and steel plate welding, and after qualitative treatment.

2. Why does the slitting machine show burrs after rolling?

If the slitting machine shows burrs after rolling, then perhaps the reason is that:

Cause one: The matching sensor device has problems in connection.

Reason two: improper use of the series of retracting and unwinding motor.

Reason three: the working speed of the stripe machine does not match the set value, or the linear speed does not match.

3. Precautions for metal slitting machine

• The operator of the metal stripe machine should be very familiar with and understand the machine and equipment, and operate in accordance with the requirements of the regulations. Illegal operation is prohibited to avoid damage to the equipment.

•  When the metal slitting machine is energized, it can not open the electric control door at will, and the electrical equipment can not be contacted at will, to avoid the danger of electric shock.

• About the feeding car, in the feeding, we should pay attention to the placement of information, should avoid its fall and hurt people. In addition, metal data, its position in the uncoiler to be accurate.

• The door of the control box in the metal slitting machine can not be opened at will. When the rolling part of the work, the operator can not use hand contact, in case of danger. In addition, we should always pay attention to the investigation of whether the operation of the stripe machine is abnormal. If so, it should be handled in time, without delay, or let the equipment work with disease.