And in the process of operation of the slitting machine equipment, it can ensure that the slitting work is stable in the set range. In addition, it is necessary to adjust the horizontal position of the cutter shaft accordingly. Horizontal spacing can be set numerically in the operation panel, and the position of the lower axis can be monitored and adjusted in real time during operation, so that the change of horizontal spacing caused by expansion and other reasons can be reduced to a small amount.

The slitting machine manufacturer installs a spindle in the center of the equipment to process the paper tube. The front end of the spindle is fixed on the base by a set of bearings and pulleys. The bearing is installed in the middle of the bearing group, the compression cylinder is installed in the appropriate position, and the supporting rod bearing group is installed on the upper end of the supporting rod of the cylinder to support the main shaft.

The main knife shaft is installed on the upper edge of the slitting machine, and a large number of blades are placed on the upper edge with a fixed gap. The main tool shaft support frame is also located at the top of the slitting machine. It is installed in the center of the support frame and has a support tube.

Start the film splice table at the working position, then manually flaten the film on a traction roller of the scutter and start the upper vacuum pump to absorb the film. Gently paste the film on the film splicing table, cut off the excess film under the tape with double-sided tape, level the film on the roll rack, and start the vacuum pump. To make the film smooth and absorbent, remove the paper layer of the tape and make the film smooth. Then close the upper and lower vacuum pumps and turn the film stage to the non-working position.

A variety of raw materials of the sprocter are combined to produce processing process edge material. According to the removal of the processing process embedded processing process edge material, the goods in line with the processing process regulations are obtained. This kind of cutting method is mainly used for the production and processing of raw materials such as composite bags.