Dongguan ManRoland Precision Machinery Co., Ltd
Contact: Mr. Jiang
Tel: 13920993307
Contact: Mr. Zhou
Tel: 18038205092
Address: No. 8, Hongye street, Xixi village, Liaobu Town, Dongguan City, Guangdong Province
Website: en.dgmll.net
In the process of using the laminating stripping machine equipment, if there is improper adjustment, there may be some abnormal phenomena, and some damage to the product will also be formed.
Some parts of the shear strips of the laminating slab-splitting machine show certain differences, which is mainly due to the uneven pressure caused by the air bag on the tension-installation, so that the strips in operation produce transverse extrusion on the isolation plate in this process.
If the width of the cutting material is found to be different, it is likely to be caused by the non-fastening of the cutting tool on the cutting machine knife shaft. Therefore, at this time, the equipment needs to be shut down, the tool is checked, and then tightened after adjustment, so that the qualified strip width can be cut out
As for the main control staff on the site, the first matters to be considered are as follows: the guide roller of the sundering machine equipment is opened to the maximum limit -- the front guide plate is swished up -- the rear looper is lifted to the guide plate the replacement and isolation according to the width of the cut strip steel.
Address: No. 8, Hongye street, Xixi village, Liaobu Town, Dongguan City, Guangdong Province Tel: 18038205092 / Mr. Zhou