The sundering machine manufacturer is actually a machine, electrical, hydraulic and integrated equipment which cuts the wide strip material into narrow strips according to the standard requirements, and is used to cut the strip into the required width standard. The electrical system of the sundering machine is mainly to control each motor, hydraulic system and gas path system of the unit. The whole electrical system is based on PLC programmable controller, equipped with intuitive man-machine interface, high precision, high performance S120 frequency conversion speed control system and other AC drive control and various detection sensors.

First, we have a brief understanding of the primary application of the splitter manufacturer. In the process of longitudinal shearing using the equipment, it has obvious advantages, including easy to operate, high cutting quality, high material utilization rate, cutting speed stepless speed regulation and other advantages, the equipment is actually the first by unwinding (unwinding), lead material positioning, sprocking longitudinal shear, coiling (rewinding) and other components.

Combined with the actual production situation to analysis, the article points the factory house of the first production process can be summarized as: prepare the volume - - open book - shovel head, head straight to pinch, leveling, the vertical roll (double) in the head and tail (cross) and shear - the vertical roll (double) in the - slitting cutting (disc) - loop - steel belt and separation to waste edge coiling, winding tension control to discharge volume, gathering.

So, what is the first role of the electrical system in the factory of the slabbing machine? In fact, the electrical system used to operate and control the entire slitting set of individual equipment, is a non-standard planning electrical control system. The control plan is very wide, such as the winding car and the unwinding car. The electronic control system consists of PLC automatic control system, AC speed control system and digital flash system. System planning and component selection comply with IS9001 and CCC standards.

In addition, in the operation process of the slabbing machine manufacturer, the staff can adjust the speed parameters set in the electrical system of the automatic balance scheduling, manual continuous adjustable function for scheduling. In the home of the sundering machine factory, the electrical system is equipped with automatic speed detection and automatic flash system. The ac frequency conversion equipment equipped with the system is equipped with an input reactor to reduce the pollution on the power network side.