As we know, in the process of slitting, the precision requirements of slitting machine manufacturers are getting higher and higher. If you want to reach the accuracy requirements, you must ensure excellent cutting quality. What kind of talent qualifies as excellent slitter quality? In fact, as far as the slabbing machine manufacturer is concerned, it is not the complete cutting of the material, but the cutting effect of the cutting section and the broken surface.

This situation is due to excellent cutting, the cutting quality can not only ensure the accuracy of the product, but also can reduce the wear of the tool, extend the service life of the machine manufacturer's equipment. In order to achieve this requirement, not only pay attention to the control of each gap, but also choose the appropriate pressure plate at the cut-off point. As we know, the blocking resistance at the cut-off point will make the material bending, distortion and other deformation.

Not only that, in this area, to avoid electroplated terminal material is also relatively simple scratches, so the need to choose the appropriate pressing method. Together with the consideration of electrical grade material strip processing also needs to be more advanced cutting quality, safe production and reduced work cost. At this time, the need for the sashing machine manufacturer equipment with appropriate knife block. When planning the knife block, we should generally pay attention to the simple setting of horizontal interval and stacking amount.

And in the process of the slitting machine factory equipment work, it can ensure that the slitting operation is stable in the set range. In addition, it is necessary to adjust the horizontal orientation of the cutter shaft accordingly. The horizontal interval can be set numerically in the operation panel, and the position of the lower axis can be monitored and adjusted in real time during the work, so that the change of the horizontal interval caused by swelling and other reasons can be minimized.

Combined with the above introduction, it can be seen that in the process of the sessionmachine factory equipment, the sessionquality must be strictly controlled. Not only do we need to pay attention to reasonable operation, but also the control of its various equipment will affect the scuttling quality and the shape of the product roll. Especially about the drive and control of the knife shaft and material speed control is very important.