We know that in the process of processing some data using the sprocter equipment, due to the influence of some factors, there may be burr, poor width and even side bending. If the product production accuracy requirements are more severe, then we need to take certain measures in time.

Due to the operation of the slitting machine equipment, the actual slitting quality is often affected by tools and other components. Also consider the fundamental function of the knife block. First of all, during the production period, if the knife shaft vibrates in the axial or radial direction, it may cause the change of the gap and overlap amount, so it is bound to affect the cutting quality of the product. In other words, it may cause the appearance of the product to show burr, side bending and distortion and other adverse phenomena.

These phenomena will reflect the fundamental function of the stripe machine equipment. Under normal conditions, during the operation of the cutter block, the bearing temperature of the cutter shaft will rise, and the cutter shaft will also change the gap amount due to thermal expansion. This will also bring certain negative effects on quality. Therefore, the problem of thermal expansion should be taken into account when planning and making the knife block, and the relative difference between the upper and lower axes should not exceed five microns in the assembly process.

In fact, during the production of the slabbing machine equipment, if you want to achieve higher accuracy requirements, you should not only pay attention to the vibration accuracy of the tool shaft in the axial and radial direction, but also ensure the accuracy of the tool shaft itself. With respect to the cutter shaft diameter, the cutter diameter shall be maintained between 0.01 and 0.015 mm. That is to say, as a benchmark knife shaft also need to achieve high accuracy.

In addition, it is necessary to ensure the movement function of the cutter shaft on the slitting machine equipment. This is because during the operation of the slitting machine equipment, the bearing of the shaft shoulder as the tool reference plane is in operation, because of the wear of the parts, it will follow the attack must change. Therefore, we should also consider this problem when planning.