In order to ensure the stable operation of the splitter equipment in the later period, the plane positioning should be done well in the process of the device. Considering the requirements of the device, the equipment should be accurately placed on the basis first. After the equipment is lifted and placed in place, the reference line should be hung according to the installed central standard plate. The datum line shall be hung according to the accuracy requirements of the equipment and equipment of the slant machine and the whole steel wire with a diameter of 0.3 to 0.75 mm shall be selected for the hanging span.

In the process of the base line hanging, horizontal or skew hanging set the best span is within 40 meters, together with the tension to ensure that the steel wire to maintain the breaking force of 40% to 80%. The datum line should be hung on the line frame easy to adjust, with the line hammer on the center point, in the center of the steel wire with the pulley can be determined, so that the steel wire in use does not attack displacement. But during the use should be regular reinspection, to avoid the attack of steel line displacement.

Secondly, it also needs to adjust the elevation of the slitting machine equipment. Usually when setting its elevation, it is mainly based on the operation surface of the equipment as the measurement datum or measurement datum. According to the permanent reference point, an auxiliary reference point may be set near the equipment to facilitate the elevation adjustment of the equipment during installation.

Next, the levelness of the shredder equipment needs to be adjusted accordingly. Under normal circumstances, if it is the whole device, then the need for the operation surface of the equipment or the surface of the assembly joint is directly measured with a level. According to the accuracy of the device of the equipment, the level of different precision can be selected, and the highest level can be 0.02mm/m.

If it is a separating device, then it needs to be leveled separately. In addition, it is also necessary to adjust the sag of the slitting machine equipment. The vertical of the slitting machine equipment can be adjusted by the measuring method of hanging steel wire. A line frame is arranged above the stripe machine equipment, a steel line is hung on the line frame, and a line hammer is hung at the lower end. The hammer is put in an oil drum, and then the distance between the equipment and the steel line is measured with the inner diameter micrometer.