In the process of using the laminating stripping machine equipment, if there is improper adjustment, there may be some abnormal phenomena, and some damage to the product will also be formed. For example, in a lifetime work, there are different widths of the strips cut by the laminates slabbing machine equipment, and the burrs of some strip products exceed the standard requirements.

First of all, for the first problem, if the width of the cutting material is found to be different, it is likely to be caused by the non-fastening of the cutting tool on the cutting machine knife shaft. Therefore, at this time, the need to shut down the equipment, check the tool, and then tighten after adjusting, can cut out the qualified strip width.

Secondly, if it is found that the burr of the strip cut by the laminating machine equipment exceeds the standard, it needs to be considered from two aspects. One is that the burr of the strip exceeds the standard after rolling cutting. The main reasons include: 1. The cutting edge is not sharp, and the burr on the strip is continuous; 2. The cutting edge is defective, and the phenomenon is that the burr on the strip has intermittent bright spots. At this point should be toughened grinding tool; 2. When the cutter clearance or overlap degree is large, the burr on the strip is continuous and has a slight upturning phenomenon. In this case, the machine should be stopped for inspection and the tool clearance should be readjusted.

Another condition is that after tension installation, the burr of the material exceeds the standard. Usually, if the burr of the strip exceeds the standard after tension installation, it is mainly caused by transverse extrusion of the isolation plate during the operation of the strip. This may be due to the flatness of the isolation plate configured in the lamination strip unit and the straightness of the shaft installed with the isolation plate, and the radial runout of the isolation plate is too large during rotation, which causes the strip to squeeze the isolation plate horizontally during operation.

If it is found that some parts of the shear strips of the laminating slabbing machine show certain differences, this is mainly due to the uneven pressure of the air bag on the tension installation, so that the strips in operation produce transverse extrusion on the isolation plate in this process. The condition should adjust the upper and lower pressure plates on the airbag, change the arrangement and increase or reduce the number of pressure plates, so that the air bag partial pressure average condition.