What is the fundamental key to the safe operation of the splitter

During the operation of the slitting machine, if there is a problem of lateral swing of the tool, it will lead to poor scale, for example, the transverse swing of the tool and the outside diameter of the tool are different and bad. Because the lateral swing of the tool cannot be zero. Usually the lateral swing value of its load is about 0.03-0.05mm. The reason is the error of cutter thickness, inner diameter, width of distance sleeve and the warping caused by lateral stress when the thick plate is shear.

During the production of the slabbing machine, the steel plate has the problem of transverse warping, resulting in the poor width and scale. This is because in the transverse warpage condition of the cut product measurement than the knife set value is larger. Because with the production and operation of the slitting machine equipment, there are certain cooperation errors in the distance sleeve and cutting tools. Under normal circumstances, the distance sleeve, tool thickness accuracy is 0.005. When the number of pieces is larger, the cumulative error becomes larger. This is because the upper tolerance is not set properly. To know, the total width of the sundering machine cut products than the knife of the product side scale slightly tolerance. Therefore, it is necessary to predict the extent of this decline in advance. Refer to the measurement of the distance sleeve when the knife is matched on the product side. The choice of cutting method should also be considered. In contrast, if the sbent machine equipment is used to cut straight, then the tension of the steel coil will increase, the transverse warping will disappear, and the scale will go down.

The fundamental key to the safe operation of the stripe machine

Before the use of the slitting machine, we must be clear about the fundamental key to its safe operation, so as to ensure the smooth production. The following small edition will tell you about the fundamental key to the safe operation of the slitting machine.

First, the application environment requirements of the slitting machine:

The machine should be installed in a place with proper temperature, dry, ventilated, good light and convenient operation. In addition, in daily use, we should insist on the neat use of the environment, and often clean the machine and insist on cleanliness.

Two, the operation requirements of using the slitting machine:

To use high-quality slitting knife and transverse cutting knife, the machine will be the whole roll or the whole piece of raw material for fixed length cutting processing; The fixed length scuttling control of the machine needs to be divided into static and dynamic scuttling. The important performance index of the fixed length scuttling of the machine is scuttling accuracy and the consistency of the finished length is good. The slitting length of the machine can be set successively. If the slitting length is wrong in practice, it needs to be calibrated by setting parameters.