How to adjust the tension of the splitter?

1. For the tension control of the splitter, its crucial problem depends on the fact that, in addition to the steady state when its angular velocity is stable, the system software for it also rules that it is in the case of constant tension unwinding, there is also the case of variable tension winding. That is to say, during the whole process of winding up, its winding up tension is to be adjusted relative to one's winding up.

2. About the tension control of the splitter, that is to say, the tension taper operation. Its key effect to the words of that is to prevent people of waterproofing materials internal stress in extension, then have to words can make by shaft strip, surrounding the core would be there for kneading molding, then words appear deformation worse knit, then can form waste, in that case, will lead to people near the plate strip between the outer edge appears overlap each other, This may result in an unsplit situation.

3. As a result, people should pay attention to the operation of the splitter, whether it is winding or winding, its winding diameter in the whole process of operation of the splitter, is full of changes in the big field of time, to form a major parameter of the automatic control system to match the big field change. In that case, there is an end result to immediately compromising the dynamic and static data quality of the system software.

4. In view of this, people should understand that the system software of its stripe machine is good or bad, the key is to see whether people's system software can do it a processing process rules. Take care to operate with a better design concept, in terms of the system software itself, but also to ensure that there is a very good mechanical and electrical equipment characteristics.