Slitting machine production process and electrical system overview

The slabbing machine is actually a machine, electrical, hydraulic and integrated equipment, which can divide wide strip information into narrow strips according to standard requirements. Cut the section to the desired width. The electrical system of the separation unit is used for the motor, hydraulic system and pneumatic system of the control unit. The whole electrical system is centered on PLC programmable controller, with intuitive man-machine interface and high-precision, high-performance S120 frequency control system and other communication driver controls and various detection sensors.

First, let's take a brief look at the current state of the split unit's primary purpose. In the process of longitudinal cutting using this device, it has obvious advantages, including convenient operation, high cutting quality, high data utilization and stepless speed regulation of cutting speed. (uncoiling), material positioning, slitting and slitting, coiling (rewinding), etc.

Combined with the actual production condition, longitudinal cutting unit of the main production process can be summarized as: ready to roll and winding - rolling - shovel head, straight head and clamping, leveling and on the vertical roll (double row) to cut the heads (cross), on the (vertical roll double row) and cutting (disc cutting) to the curved needle machine, steel belt separation To scrap edge winding, winding tension control - uncoiling - collection.

So, what role does the electrical system play in the distribution unit? In fact, the electrical system is used to operate and control the various equipment throughout the slitting unit, which is a non-standard planned electrical control system. The range of control is very wide, such as the roll trolley and the unloading trolley. The electronic control system is composed of PLC active control system, communication speed control system and digital display system. System planning and component selection comply with IS9001 and CCC standards.

In addition, during the operation of the split unit, the speed parameters in the electrical system can be adjusted to adjust the activity balance and manual adjustment. In the slitting unit, the electrical system is equipped with an active board speed detection and an active display system. The communication frequency conversion equipment of the system is equipped with input reactor to reduce the pollution to the power grid side.