There are different reasons for the problem of cutting strip products by slitting machine

In fact, through the analysis of the problems occurred in the production of the slitting machine equipment, it is helpful to adopt the optimal and perfect method for the slitting equipment. In this way, the function of the slitting machine equipment can be changed, and then the problem of longitudinal shear is solved, and the quality of the strip after shearing is improved.

Combined with the development of relevant occupations, the function of the splitter equipment has become more and more demanding. For example, steel pipe, light industry, automobile, construction, machinery and other occupations, more and more strip steel to be used. So what are the different problems that can occur to the strip during the shearing process? These problems not only affect the rate of finished products and qualified rate, but also reduce the economic benefits of enterprises. Next, we will analyze several common problems, hoping to be helpful.

First of all, in the process of slitting machine, a common problem is that there are burrs on the surface of the product. This may be because the radial cutting depth of the disc cutting blade is too small or the axial open space is too large, or it may be because the cutting blade has severe wear and tear after long-term use, and it should be sharpened or replaced in time. In addition, it may also be because of the operation of the strip against the center line at both ends of the tension is not equal to the problem of more burrs.

Second in the process of producing, also may be found on the surface of strip steel shear wave edge, this is probably because the slitting machine in the process of cutting, uncoiler, rotary shears, coiler three points against the center of, perhaps is perpendicular to the axis of shear blade surface uniform clearing intrusive uneven ladle severe form, also may be because the raw material strip steel ribbon.

In addition, many users are also faced with poor quality of product surface interception. The reason why such a problem occurs is primarily because the horizontal space and vertical space of the stripe machine are set improperly. In fact, horizontal and vertical clearance to ensure that the conditions between the cutting quality, according to the tensile strength, ductility, hardness and heat treatment state of the material selected suitable horizontal and vertical clearance.