Laminating slitting machine is a paper processing equipment primarily used for matrix paper mills for sheet printing, and for printing in post-election plastic processing, honeycomb packaging cardboard, but can also be used for slitting machines to cut honeycomb paper cores. In recent years, the development of manufacturing industry is strong, machine point, there is also a broader market in this field. Slitting machines are used in non-file processing. Slitting machine is a kind of general equipment, widely used in the printing industry, almost all you need to configure a sub-machine, laminating slitting machine printing machinery products occupy a more important position.

Said the joint article points the evolution course of rolling tension control machine, and we will have a simple chat laminating machine traction structure principle, when it comes to drawing, we will naturally think of to have a power supply, then laminating slitting machine of the power supply is motor, the motor of a lot of more phyletic, tape laminating slitting machine is commonly used ordinary motor and deceleration or frequency conversion motor, Most high-speed laminating splatters of adhesive, film, release paper or composite materials use asynchronous servo motors. The common point is that they are controlled by frequency converters, but there is a difference between open loop and closed loop in the control mode. In addition to traction power, traction bars fall into several categories:

1. Embossing traction roller, this kind of traction roller is mainly used for ordinary adhesive tape laminating slitting machine, rewinding machine, roller surface spraying iron fron anti-stick;

2. Anti-stick silicone rubber traction roller, used for processing equipment of protective film products;

3. Silicone rubber combined traction roller, composed of upper and lower, cylinder control stroke and pressure, used for the traction of non-adhesive materials and composite materials;

In the past, the speed of magnetic powder clutch of laminated stripe machine can not be too high, because it is easy to cause the high-speed friction of magnetic powder in operation, easy to produce high temperature, shorten its service life, serious will be stuck, so that the machine is blocked in operation, which brings very serious consequences to production.

1. Cutting edge, lamenting the slabbing machine after a variety of raw materials compound processing process edge material, according to the removal of processing process embedded processing process edge material, in accordance with the processing process rules of the product. This kind of cutting method is used for the production and processing of raw materials such as composite bags.

2. Roll cutting: The whole bundle of wide-width waterproof rolling material lamenting the slitting machine is cut into multiple rolls of narrow size waterproof rolling material according to the high-speed round knife. This kind of cutting method is used for adhesive products manufacturing profession.

3. Coiling, the large wave diameter raw materials of lamenting slitting machine shall be cut into multi-coil and small-coil diameter raw materials according to the rules of winding length specifications and winding width specifications and models. This kind of cutting method is used for plastic film sheet and packaging bag color printing manufacturing occupation.