A main knife shaft is arranged on the upper end of the slitting machine, and a plurality of blades are arranged on it, and arranged according to a certain gap; A supporting frame of the main knife shaft is also arranged at the top of the paper tube scutter, and a supporting cylinder is arranged in the middle of the supporting frame.

The daily maintenance of the slitting machine should be in place. The criterion is smooth and clean to ensure that the sliding part of the equipment is in good condition.

When we are cutting the length of the slitting machine, we should operate and use our slitting machine according to the length of the slitting machine process requirements. The correct way to operate and use the slitting machine is what we need.

After the normal operation of the stripper, the engine will run for free, check whether there is any abnormality, and then enter the order in advance. After work, the equipment should be adjusted in time according to the production conditions of relatively working conditions, to ensure medium pressure, cutting burr, the right side of the flat position.

During the operation of the slitting machine, it can ensure that the slitting works stably within the set range. In addition, it is necessary to adjust the horizontal position of the cutter shaft accordingly. During operation, the splitter also monitors and adjusts the position of the lower axis in real time, so that the change of horizontal clearance caused by expansion and other reasons is reduced to a small amount.

When we are running the slitting machine equipment, we need to strictly control the slitting quality. We all need to produce in accordance with the standard of the excellent slitting machine, and the quality of the products produced should be kept in accordance with the requirements.

Slitting machine good cutting, slitting quality can ensure the accuracy of the product, but also reduce the tool wear, extend the service life of the slitting machine equipment. Attention should not only be paid to the control of each gap, but also at the cutting point to choose the appropriate pressure plate. We know that the cutting resistance at the cutting point of the splitter will make the material bend, distort and other deformation.