Slitting machine manufacturers talk about the impact of accuracy

Today, let's talk about the impact of the precision of the splitter is not high enough. Next, let's understand it together.

1. The precision of the sundering machine equipment is not enough, mainly refers to two cases, one is the difference between the upper and lower knife shaft shoulder, the other is not parallel between the upper and lower knife shaft.

2. The size of these gaps will affect the quality of the edge burr of the cutting material to a certain extent. In general, if the clearance is too large, the edge burrs will be large. On the contrary, the gap is too small, the edge of the material may form a broken burr. Therefore, if the precision of the circular cutter is not high, it may have different effects on the cutting edge of the strip.

3. In addition, it also includes another case, that is, the accuracy of the circular knife meets the requirements, and the accuracy of the splicing machine equipment is also guaranteed, but there is a difference between the shoulder of the upper and lower knife shaft. In this case, it will cause the gap on both sides of the strip to change, so that both sides of the strip burr.

4. Under such conditions, the slitting machine equipment for copper cutting quality can not be guaranteed. If the slit is narrow and thick copper plate, because of the different deformation on both sides, it may also lead to side bending of the belt material.